Buick Enclave manuals

Buick Enclave: Automatic Transmission Shift Lock Control Function Check. Ignition Transmission Lock Check. Park Brake and P (Park) Mechanism Check

Buick Enclave 2008-2017 Owners Manual / Vehicle Care / Vehicle Checks / Automatic Transmission Shift Lock Control Function Check. Ignition Transmission Lock Check. Park Brake and P (Park) Mechanism Check

Automatic Transmission Shift Lock Control Function Check

When you are doing this inspection, the vehicle could move suddenly. If the vehicleWARNING
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.

1. Before starting this check, be sure there is enough room around the vehicle. It should be parked on a level surface.
2. Firmly apply the parking brake. See Parking Brake .
Be ready to apply the regular brake immediately if the vehicle begins to move.
3. With the engine off, turn the ignition on, but do not start the engine. Without applying the regular brake, try to move the shift lever out of P (Park) with normal effort. If the shift lever moves out of P (Park), contact your dealer for service

Ignition Transmission Lock Check

While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.

► The ignition should turn to LOCK/OFF only when the shift lever is in P (Park).

► The ignition key should come out only in LOCK/OFF.

Contact your dealer if service is required.

Park Brake and P (Park) Mechanism Check

When you are doing this check, the vehicle could begin to move.WARNING
When you are doing this check, the vehicle could begin to move.

You or others could be injured and property could be damaged.

Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.

Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.

► To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.

► To check the P (Park) mechanism's holding ability:

With the engine running, shift to P (Park). Then release the parking brake followed by the regular brake.

Contact your dealer if service is required.

READ NEXT:

 Wiper Blade Replacement. Windshield Replacement

Wiper Blade Replacement Windshield wiper blades should be inspected for wear or cracking. See Maintenance Schedule  for more information. Replacement blades come in different types and are remo

 Headlamp Aiming

Headlamp aim has been preset at the factory and should need no further adjustment. However, if your vehicle is damaged in a crash, the headlamp aim may be affected. Aim adjustment to the low-beam h

SEE MORE:

 Repair Instructions

STEERING LINKAGE INNER TIE ROD INSPECTION Special Tools GE-8001 Dial Indicator Set For equivalent regional tools, refer to Special Tools. 1. Turn the ignition key to the ON position with the engine OFF. NOTE: This inspection procedure does not supersede local government required inspections that

 Tire Pressure. Tire Pressure Monitor System. Tire Pressure Monitor Operation

Tire Pressure Tires need the correct amount of air pressure to operate effectively. Notice: Neither tire underinflation nor overinflation is good. Underinflated tires, or tires that do not have enough air, can result in: ► Tire overloading and overheating which could lead to a blowout.

© 2016-2025 Copyright www.benclave.com