Buick Enclave manuals

Buick Enclave: Brake System Warning Light

The vehicle brake system consists of two hydraulic circuits.

If one circuit is not working, the remaining circuit can still work to stop the vehicle. For normal braking performance, both circuits need to be working.

If the warning light comes on, there is a brake problem. Have the brake system inspected right away.

This light should come on briefly when the ignition key is turned to ON/RUN.

This light should come on briefly when the ignition key is turned to ON/RUN. If it does not come on then, have it fixed so it will be ready to warn if there is a problem.

This light may also come on due to low brake fluid. See Brakes  for more information.

When the ignition is on, the brake system warning light will also come on when the parking brake is set.

The light will stay on if the parking brake does not release fully. If it stays on after the parking brake is fully released, it means there is a brake problem.

If the light comes on while driving, pull off the road and stop carefully.

Make sure the parking brake is fully released. The pedal may be harder to push or, the pedal may go closer to the floor.

It may take longer to stop. If the light is still on, have the vehicle towed for service. See Towing the Vehicle .

The brake system might not be working properly if the brake system warning lightWARNING
The brake system might not be working properly if the brake system warning light is on.

Driving with the brake system warning light on can lead to a crash. If the light is still on after the vehicle has been pulled off the road and carefully stopped, have the vehicle towed for service.

The brake message remains on until any DIC button is pressed.

The brake light remains on until the problem is fixed. See Brake System Messages  for more information.

READ NEXT:

 Antilock Brake System (ABS) Warning Light

The ABS warning light comes on briefly when the ignition key is turned to ON/RUN. This is normal. If the light does not come on then, have it fixed so it will be ready to warn you if there is a

 Tow/Haul Mode Light

This light comes on when the Tow/Haul mode has been activated. For more information, see Tow/Haul Mode .

 StabiliTrak® Indicator Light

This light comes on briefly while starting the engine. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indicator light goes off. If it stays on,

SEE MORE:

 Airbag System

The vehicle has the following airbags: ► A frontal airbag for the driver. ► A frontal airbag for the front outboard passenger. ► A seat-mounted side impact airbag for the driver. ► A seat-mounted side impact airbag for the front outboard passenger. ► A roof-rail ai

 Description and Operation

REAR DRIVE AXLE DESCRIPTION AND OPERATION Fig. 51: View Of Rear Drive Axle Assembly The rear drive axle assembly in this vehicle consists of an aluminum housing which contains an electric clutch which is located in the driveline torque tube (for vehicles equipped with all wheel drive AWD only) an

© 2016-2024 Copyright www.benclave.com