Buick Enclave manuals

Buick Enclave: Changing a Flat Tire

Buick Rainier / Buick Rainier Owners Manual / Service and Appearance Care / Tires / Changing a Flat Tire

If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on your vehicle’s hazard warning flashers.

CAUTION:
Changing a tire can be dangerous. The vehicle can slip off the jack and roll over or fall on you or other people. You and they could be badly injured or even killed.

Find a level place to change your tire. To help prevent the vehicle from moving:

1. Set the parking brake firmly.
2. Put the shift lever in PARK (P).
3. Turn off the engine and do not restart while the vehicle is raised.
4. Do not allow passengers to remain in the vehicle.
To be even more certain the vehicle will not move, you should put blocks at the front and rear of the tire farthest away from the one being changed. That would be the tire, on the other side, at the opposite end of the vehicle.

When your vehicle has a flat tire, use the following example as a guide to assist you in the placement of wheel blocks.

The following information will tell you next how to

The following information will tell you next how to use the jack and change a tire.

READ NEXT:

 Removing the Spare Tire and Tools

The jacking equipment you will need is stored under the rear seat on the passenger’s side of the vehicle. To release the jack from its holder, turn the knob on the jack counterclockwise to low

 Removing the Flat Tire andInstalling the Spare Tire

1. If your vehicle has a wheel cap that covers the wheel nuts, position the chisel end of the wheel wrench in the notch and pry it off. 2. Using the wheel wrench, loosen all the wheel nuts.

SEE MORE:

 Conference Calling

Conference calling and three-way calling must be supported on the Bluetooth phone and enabled by the wireless service carrier to work. To start a conference while in a current call: 1. Turn the Menu Knob and press SELECT. 2. Select Enter Number. 3. Enter the character sequence then s

 Playing an MP3

Insert a CD partway into the slot (Single CD Player), or press the load button and wait for the message to insert disc (Six-Disc CD Player), label side up. The player pulls it in, and the CD should begin playing. (Tune): Turn this knob to select MP3 files on the CD currently playing. :

© 2016-2025 Copyright www.benclave.com