Buick Enclave: License Plate Lamp. Replacement Bulbs
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate
trim.
cvsot.com 2. Turn and pull the license plate lamp forward through the liftgate trim opening.
3. Turn the bulb socket counterclockwise and pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license plate lamp.
Replacement Bulbs
For replacement bulbs not listed here, contact your dealer.
READ NEXT:
High Voltage Devices and Wiring
WARNING
Exposure to high voltage can cause shock, burns, and even death. The high voltage
components in the vehicle can only be serviced by technicians with special
SEE MORE:
SPECIFICATIONS
WHEEL ALIGNMENT SPECIFICATIONS
Alignment Condition: Full tank of fuel, no passengers and placed on flat
level surface.
Wheel Alignment Specifications
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
WHEEL ALIGNMENT MEASUREMENT
Steering and v
Engine Heater
The engine coolant heater can provide easier starting and better fuel economy
during engine warm-up in cold weather conditions at or below 0°F (−18°C). Vehicles
with an engine coolant heater should be plugged in at least four hours before starting.
Some models may have an
