Buick Enclave: License Plate Lamp. Replacement Bulbs
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate
trim.
2. Turn and pull the license plate lamp forward through the liftgate trim opening.
3. Turn the bulb socket counterclockwise and pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the license plate lamp.
Replacement Bulbs
For replacement bulbs not listed here, contact your dealer.
READ NEXT:
High Voltage Devices and Wiring
WARNING
Exposure to high voltage can cause shock, burns, and even death. The high voltage
components in the vehicle can only be serviced by technicians with special
SEE MORE:
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC WIRING DIAGRAMS
STEERING WHEEL WIRING SCHEMATICS
Heated Steering Wheel
Fig. 1: NO CONTENT
TILT/TELESCOPING STEERING COLUMN WIRING SCHEMATICS
N38
Fig. 2: NO CONTENT
DIAGNOSTIC INFORMATION AND PROCEDURES
Steering Wheel Adjustment
1. Pull the lever (A) down.
2. Move the steering wheel up or down.
3. Pull or push the steering wheel closer or away from you.
4. Push the lever (A) up to lock the steering wheel in place.
Power Tilt Wheel
For vehicles with the power tilt and telescope whee
