Buick Enclave manuals

Buick Enclave: Roof

Buick Enclave 2008-2017 Owners Manual / Keys, Doors, and Windows / Roof

Sunroof

The ignition must be in ON/RUN or ACC/ACCESSORY to operate the sunroof and power sunshade.

See Retained Accessory Power (RAP) .

The vehicle may have a sunroof over the front seats and a rear sunroof over the second row seats.

The rear sunroof does not open.

The switch to operate the front sunroof is on the headliner above the rearview

The switch to operate the front sunroof is on the headliner above the rearview mirror.

Vent: From the closed position, press and hold the front of the switch to vent the sunroof. Press and hold the rear of the switch to close the sunroof.

Express-open/Express-close:

From the closed position, press and release the rear of the switch to express-open the sunroof. Press and release the front of the switch to express-close the sunroof.

Manual Sunshade

The front sunshade must be opened and closed manually.

To open the sunshade, press the button on the sunshade handle to release it and guide it back.

To close the sunshade, pull the sunshade forward until it latches.

Do not keep the sunroof open for long periods of time while the vehicle is not

Do not keep the sunroof open for long periods of time while the vehicle is not in use. Dirt and debris may collect on the sunroof seal or in the track. This could cause an issue with sunroof operation, noise, or plugging the water drainage system. Periodically open the sunroof and remove any obstacles or loose debris. Wipe the sunroof seal and roof sealing area using a clean cloth, mild soap, and water.

Do not remove grease from the sunroof.

READ NEXT:

 Head Restraints

The vehicle's front seats have adjustable head restraints in the outboard seating positions. WARNING With head restraints that are not installed and adjusted properly, there is a greater cha

SEE MORE:

 Ride Control System Messages. Airbag System Messages. Anti-theft Alarm System Messages

Ride Control System Messages SERVICE STABILITRAK This message displays if there is a problem with the StabiliTrak® system. If this message appears, try to reset the system. Stop; turn off the engine for at least 15 seconds; then start the engine again. If this message still comes on, it mean

 Specifications, Diagnostic Information and Procedures

SPECIFICATIONS APPROXIMATE FLUID CAPACITIES Approximate Fluid Capacities FASTENER TIGHTENING SPECIFICATIONS Fastener Tightening Specifications ADHESIVES, FLUIDS, LUBRICANTS AND SEALERS Adhesives, Fluids, Lubricants and Sealers COMPONENT LOCATOR TRANSFER CASE DISASSEMBLED VIEW Fig. 1: Disassemble

© 2016-2025 Copyright www.benclave.com