Buick Enclave manuals

Buick Enclave: Roof

Buick Enclave 2008-2017 Owners Manual / Keys, Doors, and Windows / Roof

Sunroof

The ignition must be in ON/RUN or ACC/ACCESSORY to operate the sunroof and power sunshade.

See Retained Accessory Power (RAP) .

The vehicle may have a sunroof over the front seats and a rear sunroof over the second row seats.

The rear sunroof does not open.

The switch to operate the front sunroof is on the headliner above the rearview

The switch to operate the front sunroof is on the headliner above the rearview mirror.

Vent: From the closed position, press and hold the front of the switch to vent the sunroof. Press and hold the rear of the switch to close the sunroof.

Express-open/Express-close:

From the closed position, press and release the rear of the switch to express-open the sunroof. Press and release the front of the switch to express-close the sunroof.

Manual Sunshade

The front sunshade must be opened and closed manually.

To open the sunshade, press the button on the sunshade handle to release it and guide it back.

To close the sunshade, pull the sunshade forward until it latches.

Do not keep the sunroof open for long periods of time while the vehicle is not

Do not keep the sunroof open for long periods of time while the vehicle is not in use. Dirt and debris may collect on the sunroof seal or in the track. This could cause an issue with sunroof operation, noise, or plugging the water drainage system. Periodically open the sunroof and remove any obstacles or loose debris. Wipe the sunroof seal and roof sealing area using a clean cloth, mild soap, and water.

Do not remove grease from the sunroof.

READ NEXT:

 Head Restraints

The vehicle's front seats have adjustable head restraints in the outboard seating positions. WARNING With head restraints that are not installed and adjusted properly, there is a greater cha

SEE MORE:

 Engine Heater. Retained Accessory Power (RAP). Shifting Into Park

Engine Heater The engine coolant heater can provide easier starting and better fuel economy during engine warm-up in cold weather conditions at or below 0°F (−18°C). Vehicles with an engine coolant heater should be plugged in at least four hours before starting. Some models may have an

 Specifications, Diagnostic Information and Procedures

SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS Fastener Tightening Specifications SCHEMATIC WIRING DIAGRAMS ENGINE HEATING/COOLING WIRING SCHEMATICS Engine Cooling Fig. 1: Engine Cooling Wiring Schematics DIAGNOSTIC INFORMATION AND PROCEDURES DIAGNOSTIC CODE INDEX DTC P0480, P0481, P0691, P069

© 2016-2024 Copyright www.benclave.com