Buick Enclave: Turn and Lane-Change Signals

An arrow on the instrument panel cluster flashes in the direction of the turn
or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change.
Hold it there until the lane change is completed. If the lever is briefly pressed
and released, the turn signal flashes three times.
The lever returns to its starting position whenever it is released.
If after signaling a turn or lane change the arrow flashes rapidly or does not
come on, a signal bulb might be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse.
See Fuses and Circuit Breakers .
READ NEXT:
If either one of the turn signals is left on and the vehicle has been driven
more than 1.2 km (0.75 mi), a chime will sound.
Use the fog lamps for better vision in foggy or misty conditions.
The fog lamps button is on the exterior lamps control to the left of the steering
column.
► (Fog Lamps): Press the exterior
SEE MORE:
The five softkeys below the radio display are used to control the functions listed
below.
To use the softkeys:
1. Press the first or fifth softkey below the radio display to display the functions
listed below, or press the softkey below the function if it is currently displayed.
2. Press the
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
ADHESIVES, FLUIDS, LUBRICANTS AND SEALERS
Adhesives, Fluids, Lubricants and Sealers
REPAIR INSTRUCTIONS
STABILIZER SHAFT REPLACEMENT
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking
© 2016-2021 Copyright www.benclave.com