Buick Enclave: Universal Remote System Operation
Using Universal Remote
Press and hold the appropriate Universal Remote button for at least half of a second. The indicator light will come on while the signal is being transmitted.
Erasing Universal Remote Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote device:
1. Press and hold down the two outside buttons until the indicator light begins
to flash, after 20 seconds.
2. Release both buttons.
Reprogramming a Single Universal Remote Button
To reprogram any of the three Universal Remote buttons, repeat the programming instructions earlier in this section, beginning with Step 2.
For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada) or Customer Assistance Offices (Mexico) .
READ NEXT:
Exterior Lamp Controls
The exterior lamps control is located on the instrument panel to the left of
the steering wheel.
It controls the following systems:
► Headlamps
► Taillamps
► Parking Lamps
&
SEE MORE:
Service Vehicle Messages
SERVICE A/C (Air Conditioning) SYSTEM
This message displays when the electronic sensors that control the air conditioning
and heating systems are no longer working.
Have the climate control system serviced by your dealer if you notice a drop
in heating and air conditioning efficiency.
SERVICE
Diagnostic Information and Procedures
TRANSMISSION FLUID COOLER FLUSHING AND FLOW TEST
GM studies indicate that plugged or restricted transmission oil coolers and
pipes cause insufficient transmission
lubrication and elevated operating temperatures which can lead to premature
transmission failure. Many repeat
repair cases could have b
