Buick Enclave: Remote Keyless Entry (RKE) System. Remote Vehicle Start. Liftgate

Buick Enclave 2008-2017 Owners Manual / In Brief / Initial Drive Information / Remote Keyless Entry (RKE) System. Remote Vehicle Start. Liftgate

Remote Keyless Entry (RKE) System

The RKE transmitter is used to remotely lock and unlock the doors from up to 60 m (195 ft) away from the vehicle.

Press to unlock the driver door.

Press Press again within five seconds to unlock the driver door.

Press again within five seconds to unlock all remaining doors.

Press Lock and unlock feedback can be personalized. to lock all doors.

Lock and unlock feedback can be personalized.

To open or close the liftgate, press and hold Press and release to locate the until the liftgate begins to move.

Press and release to locate the vehicle.

Press and hold for more than two seconds to sound the panic alarm.

Press alarm. again to cancel the panic alarm.

See Remote Keyless Entry (RKE) System Operation .

Remote Vehicle Start

Starting the Vehicle

With this feature the engine can be started from outside of the vehicle.

1. Aim the RKE transmitter at the vehicle.
2. Press and release
3. Immediately after completing Step 2, press and hold When the vehicle starts, the parking lamps will turn on and remain on as long until the parking lamps flash.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.

The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Canceling a Remote Start

To cancel a remote start:

► Aim the RKE transmitter at the vehicle and press and hold until the parking lamps turn off.
► Turn on the hazard warning flashers.
► Turn the ignition switch on and then off.

See Remote Vehicle Start .

Door Locks

To lock or unlock a door manually:

► From the inside, use the door lock knob on the window sill.
► From the outside, turn the key toward the front or rear of the vehicle, or press the

button on the Remote Keyless Entry (RKE) transmitter.

Power Door Locks

: Press to unlock the doors.
See Power Door Locks . : Press to lock the doors.

See Power Door Locks .

Liftgate

To open the liftgate the vehicle must be in P (Park). Press the touch pad under the liftgate handle. To close the liftgate, use the pull cup or pull strap as an aid.

Power Liftgate

On vehicles with a power liftgate, the vehicle must be in P (Park) to operate it.

► Press and hold

on the Remote Keyless Entry (RKE) transmitter.

► Press the liftgate button on the center console.

► Press the liftgate button on the center console.
► Press the touch pad switch on the outside liftgate handle.

For more information see Liftgate .

SEE MORE:

Shift Lock Control

SCHEMATIC WIRING DIAGRAMS SHIFT LOCK CONTROL WIRING SCHEMATICS Shift Lock Control System Fig. 1: Shift Lock Wiring Schematic DIAGNOSTIC INFORMATION AND PROCEDURES DIAGNOSTIC CODE INDEX DTC B2705: GEARSHIFT UNLOCK CIRCUIT SHORT TO GROUND Diagnostic Instructions Perform the Diagnostic System Check

Roadside Assistance Program (Mexico)

As a new owner, your vehicle is automatically enrolled in the Roadside Assistance program. The services are available at no cost under the terms and conditions of the program. The Roadside Assistance program is not part of, or included, in the coverage provided by the new vehicle limited warr