Buick Enclave manuals

Buick Enclave: Halogen Bulbs. High Intensity Discharge (HID) Lighting. Taillamps, Turn Signal, Sidemarker, and Stoplamps

Buick Enclave 2008-2017 Owners Manual / Vehicle Care / Bulb Replacement / Halogen Bulbs. High Intensity Discharge (HID) Lighting. Taillamps, Turn Signal, Sidemarker, and Stoplamps

Halogen Bulbs

Halogen bulbs have pressurized gas inside and can burst if you drop or scratchWARNING
Halogen bulbs have pressurized gas inside and can burst if you drop or scratch the bulb. You or others could be injured. Be sure to read and follow the instructions on the bulb package.

High Intensity Discharge (HID) Lighting

The low beam high intensity discharge lighting system operates at a very highWARNING
The low beam high intensity discharge lighting system operates at a very high voltage.

If you try to service any of the system components, you could be seriously injured. Have your dealer or a qualified technician service them.

After an HID headlamp bulb has been replaced, the beam might be a slightly different shade than it was originally. This is normal.

Taillamps, Turn Signal, Sidemarker, and Stoplamps

A. Taillamp

A. Taillamp
B. Sidemarker Lamp

To replace one of these bulbs:

1. Open the liftgate. See Liftgate .
2. Remove the black cuff from the lamp assembly by pulling rearward from the top to unfasten it from the snap tabs.
3. Remove the two hex nuts holding the taillamp assembly in place.
4. Pull out the taillamp assembly.
5. Turn the bulb socket counterclockwise and pull it straight out to remove it.
6. Replace the bulb.
7. Reverse Steps 3 through 5 to reinstall the taillamp assembly.

When reinstalling the taillamp assembly, the pin on the taillamp assembly must line up and be inserted correctly into the opening.
8. Replace the black cuff over the lamp assembly by pushing it into the snap tabs.

READ NEXT:

 License Plate Lamp. Replacement Bulbs

License Plate Lamp To replace one of these bulbs: 1. Remove the two screws holding each of the license plate lamps to the liftgate trim. 2. Turn and pull the license plate lamp forward through t

 Electrical System

SEE MORE:

 Drive Axle Noise Diagnosis

* PLEASE READ THIS FIRST * NOTE: This is GENERAL information. This article is not intended to be specific to any unique situation or individual vehicle configuration. For model-specific information see appropriate articles where available. UNRELATED NOISES NOTE: This is GENERAL information. This ar

 Second Row Seats. Third Row Seats. Heated and Ventilated Seats

Second Row Seats   The second row seat can be folded to access the third row. Pull the sliding seat lever forward; the seat cushion folds, and the seat slides forward. See Rear Seats . Third Row Seats The third row seatbacks can be folded forward, and the seats can be removed. To fold th

© 2016-2025 Copyright www.benclave.com