Buick Enclave manuals

Buick Enclave: Head Restraint Adjustment. Safety Belts. Passenger Sensing System

Buick Enclave 2008-2017 Owners Manual / In Brief / Initial Drive Information / Head Restraint Adjustment. Safety Belts. Passenger Sensing System

Head Restraint Adjustment

Do not drive until the head restraints for all occupants are installed and adjusted properly.

To achieve a comfortable seating position, change the seatback recline angle as little as necessary while keeping the seat and the head restraint height in the proper position.

For more information see Head Restraints  and Power Seat Adjustment .

Safety Belts

 

 

Refer to the following sections for important information on how to use safety belts properly:

► Safety Belts.
► How to Wear Safety Belts Properly.
► Lap-Shoulder Belt.
► Lower Anchors and Tethers for Children (LATCH System).

Passenger Sensing System

United States

United States

Canada and Mexico

Canada and Mexico

The passenger sensing system will turn off the right front passenger frontal airbag under certain conditions. The driver airbag, seat-mounted side impact airbags, and roof-rail airbags are not affected by the passenger sensing system.

The passenger airbag status indicator will be visible on the instrument panel when the vehicle is started. See Passenger Sensing System  for more information.

READ NEXT:

 Mirror Adjustment. Steering Wheel Adjustment. Interior Lighting

Mirror Adjustment Exterior Mirrors To adjust each mirror: 1. Press (A) or (B) to select the mirror. 2. Press the control pad to adjust the mirror. 3. Press (A) or (B) again to deselect the mirro

 Exterior Lighting. Windshield Wiper/Washer. Climate Controls

Exterior Lighting The exterior lamps control is located on the instrument panel, to the left of the steering wheel. : Turns the automatic light control on or off. AUTO: Automatic operation of

SEE MORE:

 License Plate Lamp. Replacement Bulbs

License Plate Lamp To replace one of these bulbs: 1. Remove the two screws holding each of the license plate lamps to the liftgate trim. 2. Turn and pull the license plate lamp forward through the liftgate trim opening. 3. Turn the bulb socket counterclockwise and pull the bulb straight out o

 Specifications, Diagnostic Information and Procedures

SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS Fastener Tightening Specifications DIFFERENTIAL CARRIER ASSEMBLY SPECIFICATIONS Differential Carrier Assembly Specifications ADHESIVES, FLUIDS, LUBRICANTS AND SEALERS Adhesives, Fluids, Lubricants and Sealers SCHEMATIC WIRING DIAGRAMS REAR AXLE WI

© 2016-2025 Copyright www.benclave.com