Buick Enclave: License Plate Lamp
To replace one of these bulbs:
Passenger Side Shown, Driver Side Similar
1. Push the release tab (A) toward the lamp assembly.
2. Pull the lamp assembly down to remove.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
3. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).
4. Pull the bulb (B) straight out of the bulb socket.
5. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly.
6. Push the lamp assembly back into position until the release tab locks into place.
READ NEXT:
For replacement bulbs not listed here, contact your dealer.
SEE MORE:
Notice: To avoid damage, the disabled vehicle should be towed with all four wheels off the ground. Care must be taken with vehicles that have low ground clearance and/or special equipment. Always flatbed on a car carrier.
Consult your dealer or a professional towing service if the disabled vehicle
For vehicles equipped with Bluetooth capability, the system can interact with
many cell phones, allowing:
► Placement and receipt of calls in a hands-free mode.
► Sharing of the cell phone’s address book or contact list with the vehicle.
To minimize driver distraction, before dr
