Buick Enclave manuals

Buick Enclave: Universal Home Remote SystemOperation (With Three Round LED)

Buick Rainier / Buick Rainier Owners Manual / Features and Controls / Universal Home Remote System / Universal Home Remote SystemOperation (With Three Round LED)

Your vehicle may have the Universal Home Remote

Your vehicle may have the Universal Home Remote System. If there are three round Light Emitting Diode (LED) above the Universal Home Remote System buttons, follow the instructions below.

If there is one triangular LED above the Universal Home Remote System buttons, follow the instructions under Universal Home Remote System Operation (with one triangular LED).

This system provides a way to replace up to three remote control transmitters used to activate devices such as garage door openers, security systems, and home lighting.

Do not use the this system with any garage door opener that does not have the stop and reverse feature. This includes any garage door opener model manufactured before April 1, 1982.

Read the instructions completely before attempting to program the transmitter. Because of the steps involved, it may be helpful to have another person available to assist you in programming the transmitter.

Be sure to keep the original remote control transmitter for use in other vehicles, as well as, for future programming. You only need the original remote control transmitter for fixed code programming. It is also recommended that upon the sale or lease termination of the vehicle, the programmed buttons should be erased for security purposes. See “Erasing your Universal Home Remote Buttons” later in this section.

Be sure that people and objects are clear of the garage door or security device you are programming. When programming a garage door, it is advised to park outside of the garage.

If you do not know if your garage door opener is a

If you do not know if your garage door opener is a fixed code or rolling code device, open your garage door opener’s remote control battery cover.

Your garage door opener is a fixed code device if there is a panel of switches. If not, your garage door opener is a rolling code device.

READ NEXT:

 Programming Universal HomeRemote — Fixed Code

Fixed Code garage door openers are used for garage doors produced prior to 1996. Fixed code uses the same coded signal every time, which is manually programmed by setting DIP switches for a unique

 Programming Universal HomeRemote — Rolling Code

Rolling code garage door openers are used for garage doors produced after 1996 and are code protected. Rolling code means the coded signal is changed every time your remote control garage door ope

SEE MORE:

 Without Selective Ride Control

1. Move the shift lever to the left from D (Drive). The transmission will enter Manual Mode. The DIC gear indicator will change to an M followed by a number representing the gear the vehicle is currently in. 2. In Manual Mode, press the shift lever forward to upshift or rearward to

 If the Off Indicator Is Lit for an Adult-Size Occupant

If a person of adult-size is sitting in the front outboard passenger seat, but the off indicator is lit, it could be because that person is not sitting properly in the seat. Use the following steps to allow the system to detect that person and enable the front outboard passenger fron

© 2016-2025 Copyright www.benclave.com