Buick Enclave: Rear Drive Axle
READ NEXT:
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
DIFFERENTIAL CARRIER ASSEMBLY SPECIFICATIONS
Differential Carrier Assembly Specifications
ADHESIVES, FLUIDS, LUBR
REAR DIFFERENTIAL CLUTCH CONTROL MODULE REPLACEMENT
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the propeller shaft assembly. Refer to Prop
SEE MORE:
WARNING
If a floor mat is the wrong size or is not properly installed, it can interfere
with the accelerator pedal and/or brake pedal.
Interference with the pedals can cause unintended acceleration and/or increased
stopping distance which can cause a crash and injury. Make sure the floor mat d
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate
trim.
2. Turn and pull the license plate lamp forward through the liftgate trim opening.
3. Turn the bulb socket counterclockwise and pull the bulb straight out o
Specifications, Diagnostic Information and Procedures
