Buick Enclave manuals

Buick Enclave: Rear Vision Camera (RVC)

Buick LaCrosse / Buick LaCrosse Owners Manual / Driving and Operating / Object Detection Systems / Rear Vision Camera (RVC)

This vehicle may have an RVC system. Read this entire section before using it.

The RVC system can assist the driver when backing up by displaying a view of the area behind the vehicle.

WARNING!
The RVC system does not display pedestrians, bicyclists, animals, or any other object located outside the camera's field of view, below the bumper, or under the vehicle.
Do not back the vehicle using only the RVC screen or by using the screen during longer, higher speed backing maneuvers, or where there could be cross-traffic. Perceived distances may be different from actual distances.
Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check before backing by checking behind and around the vehicle.

An image appears on the navigation screen with the message Check Surroundings for Safety when the vehicle is shifted into R (Reverse).

The navigation screen goes to the previous screen after approximately 10 seconds once the vehicle is shifted out of R (Reverse).

To cancel the delay, do one of the following:

• Press a hard key on the navigation system.

• Shift into P (Park).

• Reach a vehicle speed of 8 km/h (5 mph).

READ NEXT:

 Turning the Rear Vision Camera System On or Off

To turn the RVC system on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. 5. Select Camera.

 Symbols

The navigation system may have a feature that lets the driver view symbols on the navigation screen while using the RVC. The Ultrasonic Rear Park Assist (URPA) system must not be disabled to

SEE MORE:

 When to Change Engine Oil

This vehicle has a computer system that indicates when to change the engine oil and filter. This is based on a combination of factors which include engine revolutions, engine temperature, and miles driven. Based on driving conditions, the mileage at which an oil change is indicated ca

 Playing a CD or DVD-A Disc

Press the MEM/DVD/AUX button if there is a disc in the player. It begins playing. Information about the disc and current track is shown on the display depending on the data stored. Selecting CD or DVD-A Tracks Using the control buttons: • Press or to select the previous or next t

© 2016-2025 Copyright www.benclave.com