Buick Enclave: Tires
Every new GM vehicle has high-quality tires made by a leading tire manufacturer.
See the warranty manual for information regarding the tire warranty and where to
get service. For additional information refer to the tire manufacturer.
WARNING
- Poorly maintained and improperly used tires are dangerous.
- Overloading the tires can cause overheating as a result of too much flexing.
There could be a blowout and a serious crash. See Vehicle Load Limits .
- Underinflated tires pose the same danger as overloaded tires. The resulting
crash could cause serious injury. Check all tires frequently to maintain the
recommended pressure. Tire pressure should be checked when the tires are cold.
- Overinflated tires are more likely to be cut, punctured, or broken by a
sudden impact— such as when hitting a pothole. Keep tires at the recommended
pressure.
- Worn or old tires can cause a crash. If the tread is badly worn, replace
them.
- Replace any tires that have been damaged by impacts with potholes, curbs,
etc.
- Improperly repaired tires can cause a crash. Only the dealer or an authorized
tire service center should repair, replace, dismount, and mount the tires.
- Do not spin the tires in excess of 55 km/h (35 mph) on slippery surfaces
such as snow, mud, ice, etc. Excessive spinning may cause the tires to explode.
READ NEXT:
Consider installing winter tires on the vehicle if frequent driving on snow or
ice covered roads is expected. All season tires provide good overall performance
on most surfaces, but they may not o
If the vehicle has P235/45R18 size tires, they are classified as low-profile
tires.
Notice: Low-profile tires are more susceptible to damage from road hazards or
curb impact than standard profile
SEE MORE:
To preserve the vehicle's finish, keep it clean by washing it often.
Do not wash the vehicle in direct sunlight and use a car washing soap.
Notice: Do not use cleaning agents that are petroleum based or that contain acid or abrasives, as they can damage the paint, metal, or plastic on the vehicle.
2.4L L4 Engine
1. Remove the six screws on top of
the engine air cleaner/filter
housing.
2. Lift the filter cover housing away
from the engine air cleaner/filter
housing.
3. Pull out the filter.
4. Inspect or replace the engine air
cleaner/filter.
5. Lower the filter cover housing