Buick Enclave: Parking Brake
The vehicle has an Electric Parking Brake (EPB). The switch for the EPB is in
the center console. The EPB can always be activated, even if the ignition is off.
To avoid draining the battery, do not cycle the EPB too often without the engine
running. The EPB can be left applied while the vehicle is parked. The system has
a parking brake status light and a parking brake warning light. See Brake System
Warning Light . There are also Driver Information Center (DIC) messages. See Brake
System Messages for more information. In case of insufficient electrical power,
the EPB cannot be applied or released. Before leaving the vehicle, check the parking
brake status light to ensure the parking brake is applied.
READ NEXT:
The EPB can be applied any time the vehicle is stopped. The EPB is applied by
momentarily lifting up on the EPB switch. Once fully applied, the parking brake
status light will be on. While the bra
To release the EPB, place the ignition in the ON/RUN position, apply and hold
the brake pedal, and push down momentarily on the EPB switch. If you attempt to
release the EPB without the brake peda
SEE MORE:
Up to 30 stations (six FM1, six FM2, and six AM,
six XM1 and six XM2 (if equipped), can be
programed on the six numbered pushbuttons, by
performing the following steps:
1. Turn the radio on.
2. Press BAND to select FM1, FM2, AM, or XM1
or XM2.
3. Tune in the desired station.
4. Press and h
If a person of adult size is sitting in the front outboard passenger seat, but
the off indicator is lit, it could be because that person is not sitting properly
in the seat. Use the following steps to allow the system to detect that person and
enable the front outboard passenger frontal airb
