Buick Enclave: Taillamps, Turn Signal, Sidemarker, and Stoplamps

A. Taillamp
B. Sidemarker Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate .
2. Remove the black cuff from the lamp assembly by pulling rearward from the top
to unfasten it from the snap tabs.
3. Remove the two hex nuts holding the taillamp assembly in place.
4. Pull out the taillamp assembly.
5. Turn the bulb socket counterclockwise and pull it straight out to remove it.
6. Replace the bulb.
7. Reverse Steps 3 through 5 to reinstall the taillamp assembly.
When reinstalling the taillamp assembly, the pin on the taillamp assembly must
line up and be inserted correctly into the opening.
8. Replace the black cuff over the lamp assembly by pushing it into the snap tabs.
READ NEXT:
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate
trim.
2. Turn and pull the license plate lamp forward through the liftgate trim op
For replacement bulbs not listed here, contact your dealer.
SEE MORE:
Useful information about a tire is molded into its sidewall.
The examples show a typical passenger vehicle tire and a compact spare tire sidewall.
Passenger (P-Metric) Tire Example
(A) Tire Size: The tire size is a combination of letters and numbers used to
define a particular tire
WARNING
If a floor mat is the wrong size or is not properly installed, it can interfere
with the accelerator pedal and/or brake pedal.
Interference with the pedals can cause unintended acceleration and/or increased
stopping distance which can cause a crash and injury. Make sure the floor mat d
© 2016-2021 Copyright www.benclave.com