Buick Enclave manuals

Buick Enclave: Third Row Seats

The third row seatbacks can be folded forward, and the seats can be removed.

To fold the third row seatback:

1. Remove anything on or under the seat.

2. Disconnect the rear safety belt mini-latch using a key in the slot on the

2. Disconnect the rear safety belt mini-latch using a key in the slot on the mini-buckle, and let the belt retract into the headliner.

Stow the mini-latch in the holder in the headliner.

3. Pull up on the release lever on the back of the seat.

3. Pull up on the release lever on the back of the seat.
4. Push the seatback forward to lay flat.

See Third Row Seats  for more information.

READ NEXT:

 Heated and Ventilated Seats

Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar   If available, the buttons are on the center console. To operate, the engine must be running. : If available, press to h

 Head Restraint Adjustment

Do not drive until the head restraints for all occupants are installed and adjusted properly. To achieve a comfortable seating position, change the seatback recline angle as little as necessary w

 Safety Belts

  Refer to the following sections for important information on how to use safety belts properly: ► Safety Belts. ► How to Wear Safety Belts Properly. ► Lap-Shoulder Belt

SEE MORE:

 Securing Child Restraints (Rear Seat)

When securing a child restraint in a rear seating position, study the instructions that came with the child restraint to make sure it is compatible with this vehicle. If the child restraint has the LATCH system, see Lower Anchors and Tethers for Children (LATCH System)  for how and where t

 Repair Instructions

REAR DIFFERENTIAL CLUTCH CONTROL MODULE REPLACEMENT Removal Procedure 1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. 2. Remove the propeller shaft assembly. Refer to Propeller Shaft Replacement. 3. Remove the torque tube mounting bolt. Fig. 2: Identifying Torque Tube

© 2016-2023 Copyright www.benclave.com