Buick Enclave: Wiper Blade Replacement
Windshield wiper blades should be inspected for wear or cracking.
See Maintenance Schedule for more information.
Replacement blades come in different types and are removed in different ways.
To replace the wiper blade assembly:
1. Pull the windshield wiper arm away from the windshield.
2. Press the button in the middle of the wiper arm connector and pull the wiper
blade away from the arm connector.
3. Install the new wiper blade and make sure the wiper blade locks into place.
For the proper size and type see Maintenance Replacement Parts .
Backglass Wiper Blade
To replace the backglass wiper blade:
1. Pull the wiper blade assembly away from the backglass.
The backglass wiper blade will not lock in a vertical position so care should
be used when pulling it away from the vehicle.
2. Rotate the wiper blade assembly, hold the wiper arm in position, and push the
blade away from the wiper arm.
3. Replace the wiper blade.
4. Return the wiper arm and blade assembly to the rest position on the glass.
READ NEXT:
The vehicle is equipped with an acoustic windshield. If you ever have to have
the windshield replaced be sure to get an acoustic windshield so you will continue
to have the benefits an acoustic wi
Headlamp aim has been preset at the factory and should need no further adjustment.
However, if your vehicle is damaged in a crash, the headlamp aim may be affected.
Aim adjustment to the low-beam h
For the proper type of replacement bulbs, see Replacement Bulbs .
For any bulb-changing procedure not listed in this section, contact your dealer.
SEE MORE:
A. Fan Control
B. Temperature Control
C. Air Delivery Mode Control
For vehicles with the rear climate control system, the controls are located on
the rear of the center console. The system can also be controlled with the front
controls.
Press the REAR button on the front climate control sy
COOLING SYSTEM DRAINING AND FILLING (STATIC FILL)
Draining Procedure
Special Tools
J 26568 Coolant and Battery Tester
WARNING: To avoid being burned, do not remove the radiator cap or surge
tank cap
while the engine is hot. The cooling system will release scalding fluid and
steam under pressure
© 2016-2024 Copyright www.benclave.com