Buick Enclave: Engine Heating and Cooling
READ NEXT:
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC WIRING DIAGRAMS
ENGINE HEATING/COOLING WIRING SCHEMATICS
Engine Cooling
Fig. 1: Engine Cooling Wiring S
COOLING SYSTEM DRAINING AND FILLING (STATIC FILL)
Draining Procedure
Special Tools
J 26568 Coolant and Battery Tester
WARNING: To avoid being burned, do not remove the radiator cap or surge
tank c
SEE MORE:
REAR DIFFERENTIAL CLUTCH CONTROL MODULE REPLACEMENT
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the propeller shaft assembly. Refer to Propeller Shaft Replacement.
3. Remove the torque tube mounting bolt.
Fig. 2: Identifying Torque Tube
StabiliTrak® Indicator Light
This light comes on briefly while starting the engine. If it does not, have the
vehicle serviced by your dealer. If the system is working normally, the indicator
light goes off.
If it stays on, or comes on while driving, there could be a problem with the
Stabil
Specifications, Diagnostic Information and Procedures
