Buick Enclave: Parking Brake
The vehicle has an Electric Parking Brake (EPB). The switch for the EPB is in
the center console. The EPB can always be activated, even if the ignition is off.
To avoid draining the battery, do not cycle the EPB too often without the engine
running. The EPB can be left applied while the vehicle is parked. The system has
a parking brake status light and a parking brake warning light. See Brake System
Warning Light . There are also Driver Information Center (DIC) messages. See Brake
System Messages for more information. In case of insufficient electrical power,
the EPB cannot be applied or released. Before leaving the vehicle, check the parking
brake status light to ensure the parking brake is applied.
READ NEXT:
The EPB can be applied any time the vehicle is stopped. The EPB is applied by
momentarily lifting up on the EPB switch. Once fully applied, the parking brake
status light will be on. While the bra
To release the EPB, place the ignition in the ON/RUN position, apply and hold
the brake pedal, and push down momentarily on the EPB switch. If you attempt to
release the EPB without the brake peda
SEE MORE:
To use the remote control, aim it at the transmitter window at the rear of the
overhead console and press the desired button. Direct sunlight or very bright light
could affect the ability of the RSE transmitter to receive signals from the remote
control. If the remote control does not seem t
To ensure proper engine performance and long life, careful attention must be
paid to engine oil. Following these simple, but important steps will help protect
your investment:
Always use engine oil approved to the proper specification and of the proper
viscosity grade. See “Selecting th
