Buick Enclave: Windshield Wiper/Washer
The windshield wiper/washer lever is located on the left side of the steering column.
Turn the band with the wiper symbol to control the windshield wipers.
(Mist): Use for a single wiping
cycle.
(Off): Use to turn the wipers off.
Delays wiping cycle. Turn the band up for more frequent wipes or down for less frequent wipes.
► : Slow wipes.2 : Fast wipes.
Clear ice and snow from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged wiper blades should be replaced. See Wiper Blade Replacement .
Heavy snow or ice can overload the wipers. A circuit breaker stops them until the motor cools.
Windshield Washer
(Washer Fluid): Press the button
at the end of the turn signal/lane change lever, to spray washer fluid on the windshield.
The wipers clear the windshield and either stop or return to the preset speed. The ignition key must be in ACC/ACCESSORY or ON/RUN for this to work. See Washer Fluid .
WARNING
In freezing weather, do not use the washer until the windshield is warmed. Otherwise
the washer fluid can form ice on the windshield, blocking your vision.
WASHER FLUID LOW ADD FLUID is displayed on the Driver Information Center (DIC) when the washer fluid is low. See Washer Fluid Messages .
READ NEXT:
Rear Window Wiper/Washer
The rear wiper and rear wash button is located on the instrument panel below
the climate control system.
(Rear Wiper): Press to turn the
rear wiper on and off. The wiper speed cannot be changed.
Compass
Your vehicle may have a compass in the Driver Information Center (DIC). See Driver
Information Center (DIC) for more information about the DIC.
Compass Zone
The zone is set to zone eight upo
Clock
To adjust the time and date:
1. Turn the ignition key to ACC/ACCESSORY or ON/RUN, then press
to turn the radio on.
2. Press to display HR, MIN, MM, DD,
YYYY (hour, minute, month, day, and year)
SEE MORE:
Stopping and Resuming Playback
To stop playing a DVD without turning off the system, do one of the following:
► Press on the remote control.
► Press the softkey under the stop or the play/pause icons displayed on the radio.
► If the radio head is sourced to something other than DVD-V, press the DVD/CD AU
Cylinder Head Overhaul
* PLEASE READ THIS FIRST *
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine overhaul process. Descriptions of processes
of cleaning, inspection, asse
